Featuring a modern glam gold finish with a unique geometric shape, the Teharriss Mirror exhibits glamorous mid-century vibes that’ll draw the eye to its presence.

Material:

• Wood Frame
• Glass
• MDF backboard

Prepare your Tools & Hardware

• 2 x Drywall Anchors
• 2 x Screws
• 1 x Pencil
• 1 x Screwdriver
• 1 x Measuring Tape

*Hardware & Tools are not included in the item, separately purchase*

Installation Guide

1. Before you get started with the below mounting step, use a measuring tape to measure the distance from the side edge of the Mirror to the center of the D-ring. This is "Measurement A" Repeat the same for the other D-ring, which is "Measurement B".
2. Next measure the distance between the D-ring (measure the center of each). This is "Measurement C".
3. Determine a desire mounting location. With the help of another person, hold the mirror level against wall at a desired mounting location. Use a pencil to mark out both sides of the mirror. Place the mirror aside.
4. Replicate Measurement A, B & C on the wall from the marking done in step 3. The start and end points of Measurement C will be the installation points for the mounting hardware. Use a pencil & ruler to connect all the measurements. A horizontal line should be formed. Make the necessary adjustments to ensure a horizontal installation.
5. Look out if there is any wall stud in the desired installation points, if any of the installation point aligns with stud, use metal screws only, If there is no stud, both the anchors and metal screw are required.
6. If a installation point aligns with wall stud, use a screwdriver and secure a metal screw directly into the installation point and into the aligned stud. Rotate the screw clockwise until the screw head is about 3/8 inch from the wall surface.
7. For installation point that do not align with the wall stud. use a screwdriver to insert the wall anchor. Do not "push" or drive the anchor into the wall, it is design to bore into the wall like a drill bit. Slowly turn the anchor clockwise while applying pressure until the flange just touches the wall. Again, using the screwdriver, insert a screw into the installed wall anchor and rotate the screw clockwise until the screw head resides about 3/8 inch from the wall.
8. After installation of the anchors/screws, raise the mirror against the wall so that the holes are supported by the screw heads.

Care Instructions

1. To clean/wipe with soft, dry cloth.
2. Do not use abrasive or strong chemical household cleaners.
3. A household glass cleaner may be used for the Mirror surfaces - Spray the cleaner on a clean cloth first and then use the cloth to clean the mirror.
4. Do not spray the cleaner directly onto the Mirror or frame surfaces.

NOTE

• Installation/Assembly is not provided by FortyTwo. Self assembly required.
• Hardware and Tools are not included in the item.
• Do check thoroughly the mirror front and back are in good condition before installing. The mirror might get defect during transit, contact us immediately.
• Product may vary slightly from image due to the use of natural materials. Also due to photoshoot lighting conditions and screen settings.